Applying Protecticoat is simple, but getting the best results means avoiding a few common pitfalls. Don’t let small mistakes stand in the way of a perfectly protected surface! Here’s what to watch out for:

1. Skipping Surface Preparation

A clean surface is key to proper adhesion. Dirt, grease, or old coatings can prevent Protecticoat from doing its job. Always clean and dry the area thoroughly before application.

2. Applying Too Much Product

More isn’t always better! Over-application can cause uneven coverage or dripping. Stick to the recommended amount for a smooth, effective finish.

3. Ignoring Weather Conditions

Temperature and humidity matter. Apply Protecticoat in moderate conditions for the best results. Avoid extremely hot, cold, or humid weather to ensure proper curing.

4. Neglecting to Measure Your Surface

Don’t run out mid-project! Measure your surface area beforehand and choose the right size Protecticoat to ensure full coverage without interruptions.

5. Forgetting Final Touches

After applying, give Protecticoat the proper time to cure. Rushing to use the surface too soon can impact the finish and protection level.